Humidifier installation













2 Reasons Why the Humidistat Should Be Installed Above the Humidifier

A humidistat is used for measuring and controlling the relative humidity of a place. The humidistat is attached with various humidifying equipments and is used for controlling them. The humidistat contains a sensing element for measuring humidity and a relay amplifier.

1. Proper Control

When the humidistat is used along with the humidifier you can keep a proper control over the moisture level of the room. It is not possible for you to measure the humidity of the room after a certain interval of time and then switch on or switch off the humidifier. A humidistat performs this operation on its own. The humidistat comes with a knob with which you can set the humidity level according to your need and then it will be controlled automatically.

2. Helps to Save Power and Decreases Bacterial Growth

The humidistat turns off the humidifier when the humidity of the room reaches a certain level and thus the humidifier is not consuming electricity all the time unnecessarily. Also if the humidifier is turned on for a prolonged period of time the moisture in the room will become much more than what is required. If the room is very humid then bacterial growth and other microbes will increase in number under such conditions.

3 Ways to Tell if Your Humidifier Float Valve Needs to Be Replaced

Your humidifier float valve may need replacing if any of these conditions are present. Check out these 3 ways to tell if it is time to replace your humidifier's float valve.

1. No Humidity Entering Your Room Air

The humidifier float valve may be clogged with mineral deposits from your water. Remove and clean the float valve, and reinstall it. If the water is still not reaching the vaporizing unit, the float valve is defective and must be replaced.

2. Humidifier Is Overflowing

Sometimes the opposite problem may occur with a faulty float valve. In this case, the float valve may be stuck near the top of the water reservoir. Remove the float valve and check its connector to ensure it moves freely as the water reservoir level rises and falls. If the connector is damaged or worn, replace the float valve.

3. Worn Float Valve

Inspect the humidifier every 2 months during the winter to ensure the float valve orifice and its rubber support buttons are making a tight seal. If the valve entry and the support buttons are worn down, a tight seal will not be achieved. Water can flood out of the reservoir and damage the humidifier's electrical parts. Replace the float valve if parts look worn out upon inspection.


cool mist humidifiers

Using Mini Dehumidifiers

Home Humidifier

Portable Dehumidifiers

Basement Humidifier

Dehumidifier Pump

Whole House Humidifier

How to Clean Your Humidifier

Humidifier Tank

Dehumidifier Installation

Building a Portable Cool Mist Humidifier

Replacing Pin Connectors in a Humidifier

Site map











Карта сайта